10 0 434 KB
Test Name : Preparation, marking and measuring of fabric specimens and garments in tests for determination of dimensional change Method Name : ISO 3759 : 2011 Parameter Description Scope Condition Specimen Preparation
Bench Mark
Sewing & Note Washing Procedure/ Load Detergent
Drying Procedure Conditioning Calculation Reporting
This Standard specifies a method for the preparation, marking and measuring of textile fabrics, garments and fabric assemblies for use in tests for assessing dimensional change after a specified treatment, The atmospheres used for conditioning and testing shall be in accordance with ISO 139. Avoid 1 meter from the both end of the fabric Sample Size 500mm Length 500mm Width direction Circular knitted fabrics produced on a body-width machine shall be used in their tubular form. Fabrics less than 650 mm in width, full-width specimens may be used All other fabric handled in the flat condition in a single layer. Mark warp direction before cutting out the specimen Gauge Length 350mm (3pairs) Fabrics less than 650 mm in width, full-width specimens may be used & measurements made by agreement between the parties concerned. overall length (flat made-up textile) overall width (flat made-up textile) Over Lock All Edges For Preventing Fray Effect Note Down Washing & Drying Condition & BGDT No. Washing Procedure As Per BS EN ISO 6330 : 2012 As Per Care Label Or Buyer Requirement 20 gm Detergent , 77 Parts Reference Detergent, 20 Parts Sodium Perborate & 3 Parts Bleaching Activator (TAED) As Per Care Label Or Buyer Instruction As Per BS EN ISO 6330 : 2012 As Per Care Label Or Buyer Requirement 4 Hrs After Drying After Wash Measurement – Original Measurement /Original Measurement × 100 = Dimensional Change In % Washing And Drying Procedure , Number Of Complete Washing & Drying Cycle , If Fabric Hand Ironed, Size Of Specimen & Bench Mark Dimensional Change In Nearest 0.1%
Remark
Test Name : Domestic Washing & Drying Procedure For Textile Testing Method Name : BS EN ISO 6330 : 2012 Parameter Description Scope
Washing Machine Type Ballast Type Ballast Selection Detergent
Wash Load Detergent Qnty Detergent Ratio
Drying Procedure Reporting
This Standard applicable to textile fabric , Garment , and Other Textile article which are subjected to appropriate combination of domestic washing and drying procedure .This standard also specifies reference detergent and ballast . Type A : Horizontal Axis Front Loading Vertical Axis , Top Loading Agitator Vertical Axis , Top Loading Pulsator Type Type 1 : 100% Cotton Type ii : 50% Cotton 50% Polyester Type ii : 100 % Polyester For Cellulosic Product = Type 1 Ballast For Synthetic & Blend Product = Type ii/Type iii Reference Detergent 1: AATCC Standard Reference Detergent Reference Detergent 2: IEC Reference Detergent A Reference Detergent 3: ECE Non Phosphate Reference Detergent. Reference Detergent 4: Only For Type C Washing M/C Reference Detergent 5: AATCC Standard Reference Detergent (WOB) Reference Detergent 2: IEC Non Phosphate Reference Detergent 2.0 +/- 0.1 kg For Type A Machine = 20+/- 1gm, For Type B Machine = Det. 2 = 66gm, Type 3 = Det.4 =1.33g/l 20 gm Detergent , 77 Parts Reference Detergent, 20 Parts Sodium Perborate 3 Parts Bleaching Activator (TAED) As Per Care Label Or Buyer Instruction As Per Care Label Washing And Drying Procedure , Number Of Complete Washing & Drying Cycle , Type of detergent Used . Dimensional Change In Nearest 0.1%
Remark